The following instructions will assist you in configuring the Honeywell 1400g 2D (Voyager).
The following has to be regarded when wetting up the scanner:
(A) Depending on whether you're using Windows or MAC, different barcodes have to be scanned - see below
(B) Every scan has to be accompanied by an audible "beep"
(C) It should technically be possible to scan the codes directly from the computer screen. However, should that not work for you, you can print this site [CTRL+P] /[CMND+P]
Configure Honeywell 1400g for Windows
Scan 1: Reset to Default |
 |
Scan 2: Set new default settings for Subsidia |
 |
Scan 3: configuration for Windows (Honeywell 1400g):
|
|
Scan 4: In order to verify the configuration, open the POS app and try to scan multiple items - there might be an error message for the first, which should subside after the second.
|
|
Configure Honeywell 1400g for MAC
Scan 1: Reset to Default | |
Scan 2: Set new default settings for Subsidia | |
Scan 3: configuration for MAC (Honeywell 1400g):
|
|
Scan 4: In order to verify the configuration, open the POS app and try to scan multiple items - there might be an error message for the first, which should subside after the second.
|
|
Note:
Should you have trouble with scanning QR codes, this article might help.